جميع الاقسام
EN

الصفحة الرئيسية>الأخبار

Types of hydraulic fittings

الوقت: 2022-04-07 الزيارات: 6
1) NPTF taper thread محول

Description: This is a dry seal thread; It is a domestic taper pipe thread for conveying fuel oil. It can be used for both external thread end التجهيزات and internal thread end التجهيزات. NPTF external threads can be fitted with NPTF, NPSF or NPSM internal threads. NPTF fittings are similar to BSPT fittings but not interchangeable. Most sizes of threads have different pitch and profile Angle of 60°, whereas BSPT threads have profile Angle of 55°.

صورة

2)JIC37° taper Angle internal thread محول

Description: 37° Cone Angle (JIC) The Society of Automotive Engineers (SAE) specifies that 37° cone Angle or cone holder can be used for high pressure hydraulic pipelines. This type of محول is often called a JIC محول. JIC external thread is straight thread can only be matched with JIC internal thread, JIC external thread is straight thread, and has a 37°cone seat surface, JIC internal thread is straight thread, and has a 37° cone seat surface. The seal is formed at the 37° cone seat surface. Some sizes of thread are the same as SAE45° cone thread. The cone Angle should be carefully measured to distinguish.

صورة

3)SAE 45° taper male thread adapter

Description: SAE(45° Cone Angle) This is the term used for pipe joints with a 45° cone Angle or cone seat. Soft copper pipes usually use this joint because the material can be easily machined to a 45° Angle. This joint is suitable for low pressure applications such as fuel lines and refrigeration lines. SAE 45° taper external thread can only be matched with SAE 45° taper internal thread. SAE external threads are straight threads with 45° taper seat. SAE internal threads are also straight threads and have a 45° taper mount. The seal is formed at the 45° cone seat surface. Some sizes of thread are the same as SEA 37° taper thread. The cone Angle should be carefully measured for zone running.

صورة

4) O-ring end face sealing outer thread محول

Note: O-ring end seal outer thread can only be matched with o-ring end seal inner thread, the outer thread is straight thread with O-ring; The inner thread is straight thread with sealing end face, the outer thread is sealed at the O-ring, and the inner thread is sealed at the sealing end face.

صورة